My NGX is back in my P3DV2.2 stable!...wellllll Kinda
Finally!!! Back in the NGX....in P3Dv2.2. Havent flown this sweetie since v1.4 over a YEAR AGO!!!....sorely misssed....got around the big X in the PFD. The Key is to load the NGX in a small( I suspect only Windowed mode is needed...size is not key) and WAIT in that window until the NGX is fully loaded!
...and It Worked!....but crashed in my UT SOCal KLAS environs NOT using Legacy mode...(Not sure the scenery contributed to the crash)... as I was putting the nav data into the FMC for the PE -9 test KLAS KLAX BOACH5 HEC RIVRR2 Rwy 25L....saved....then everything hung...after~5 min P3d crashed.
Soooo I reloaded in P3DV2.2 mode. I decided to load an at least 5 year old flight-"NGX in beautiful TNCM-land" (Princess Juliana St. Maartin)...used the AP a lot to do bone shaking touch and goes, then got lost..had to look at the charts for the VOR...then hand-fly it in...ohhhhhsh*t...its Rwy 18!... over the mountain!.... Do I extend and do a missed approach and bring it back around to Rwy 09 or go for 18 full stop?. ...what rush!...I knew the specs...approach.,.the controls and annunciators....the plane...but it had been over a year at the controls of my NGX.....could I do it?....watch..and ....
Notes on FSIPanel v .7 P3D RAS Duke Turbine v2
1. system rebooted P3dv2.5 5x after including the above in available ac in FSIP
-note FS Recorder loaded but not running
2. Left vectors to KLGA chosen but P3d keeps re-starting
4. unloading FSIP
5 unloading P3d
6. Loaded P3d with default ac Trike in Teterboro
loaded FSIP v1.0000.7 crashed when I went to setup launched troubleshooting test...worked a second time and sent off report
7.loaded TDuke at my AP(K69)...GPS will no longer pop-up
...
https://www.youtube.com/watch?v=wa99jUl1K9U