Getting the block halves together plus rods and pistons and measuring piston protrusion. Also pulling a fuel pressure regulator from a lly duramax engine. ... https://www.youtube.com/watch?v=AJSVEZZ0Sgs
Working in the dark under a Kenworth , to remove a clutch that the throw out bearing went out on. If you choose you can help support this channel @ https://www.patreon.com/7830jd
...
https://www.youtube.com/watch?v=Q7hSS0TPu5E
Checked power and grounds to ECM, installed good batteries, and pulled transmission and removed rear timing cove and checked timing.
...
https://www.youtube.com/watch?v=Xfmh2IvRhcg
Pulling wire harness, steering pump drive, implement pump drive , park brake housing, and some other components. If you choose you can help support this channel @ https://www.patreon.com/7830jd
...
https://www.youtube.com/watch?v=zFx7lWdmZuA
Had a comeback on a Detroit 50 series that I out of framed rebuilt, what I found wrong was the only reman part that was purchased for that build.
...
https://www.youtube.com/watch?v=sBd32YIjhTE
Pulling the rest of the liners and pistons on the 2012 mx13 386. And looking at a 2016 Mx13 in a Pete with egr codes and high hydrocarbon codes. Plus I left a couple of cool pictures of the flight home at the end of the show.
...
https://www.youtube.com/watch?v=DFg2aNib8E0