NOTE: Any "Marshall Footswitch" can be used. I included a diagram at the end of this video with working LEDS.
Below are the Fender models I tried that work right from the factory but the way they are wired it will only change the "Channels" not the "Reverb". You must follow the wiring I did here to get it to work for both "Channel & Reverb".
Model #: 0097298000
Model #: 0071359000 (Which is what I used)
...
https://www.youtube.com/watch?v=1P74t5vXpS4
DIY Fretwrap with velcro, velcro is 1" wide.
I would recommend NOT using self stick velcro has the sticky/glue might get on your guitar/bass finish. Also it will make the fretwrap bulky because you'll need to stick both pieces together of the same length & hard to bend around the neck.
...
https://www.youtube.com/watch?v=708UI9PdJSw
A guide to setting up your studio monitors & subwoofer for mixing with an SPL Meter, & some comparing of Android SPL Meter apps against a real SPL Meter.
...
https://www.youtube.com/watch?v=FGlMfKVBOBA
A special thank to "Barbarach BC" for helping me sort out the bias with the R1 & R2 resistors! Your help is much appreciated & I hope this build helps others out.
It was a lot of fun & learned a lot by reading & looking at the schematics on how such a simple circuit can be built to give such great sound, modded & tweaked to your liking.
...
https://www.youtube.com/watch?v=7YmHaG-vjn4
Riff & Song Intros, video series for beginners with "Power Chords" for Rock songs.
Marshall Origin50H, Boss GE-7, EHX Oceans 11 (front of amp)
...
https://www.youtube.com/watch?v=KlpM60GuG5o