Once I had all the parts printed I has to do a full mock to make sure the rotor will run through the coils and it does. Its a bit jankey because I have to fit the bearings better and a few other tightening tweaks but its looking good. Next is to wind the coils and the magnets are in.
...
https://www.youtube.com/watch?v=1PYxXNH7A6g
So I did hear you all and yes I realized that the monster rotor I built was done in haste and I used the the wrong size shaft and the wrong material. I'm in the process of recouping the magnets from that failed rotor.
...
https://www.youtube.com/watch?v=09BgWxlep7E
So I just did more testing and started to build a new rotor. I also revisited some older stuff and played around. I found out some important info on coil size and position. I also used the good Sky coil to play. I had to stop with the new rotor build till I can get to the hardware store tomorrow.
...
https://www.youtube.com/watch?v=wy-k-3Kzlqg