#3:2 Transistor Tester M12864 - Test Frequency Counter
Banggood DIY M12864 Graphics Version Transistor Tester Kit LCR ESR PWM With Case Testing the frequency counter after question from a viewer. ... https://www.youtube.com/watch?v=NGCdgakyXhE
This is how you can use an STL (Mesh) for reference in Solid modeling, without the need to convert the Mesh in to solid.
0:00 Intro
1:00 Inser Mesh (STL)
1:40 Check Mesh warnings
2:15 Sketch Base
2:24 Extrude Base
3:30 Mesh Section Sketch
4:11 Edit Sketch
4:20 Fit Curves to Mesh Section
5:05 Extrude Cut
5:40 Section Analyzes
6:14 Scale in X and Y direction
7:00 Inspecting clearance
...
https://www.youtube.com/watch?v=2ruuidSS99g
This is a short video of me designing a regular icosahedron (platonic solid) in Fusion 360.
Using no math or angles, making the software do all the "hard" work.
The model is parametric in that there is only one dimension, then changing the dimension in the first sketch the final solid body updates.
This is also know as the D20 dice.
Hope this is useful for you out there :)
https://en.wikipedia.org/wiki/Regular_icosahedron
https://en.wikipedia.org/wiki/Platonic_solid
...
https://www.youtube.com/watch?v=YcpB4HZJDio
A short workflow (question is from the Autodesk Fusion 360 forum)
0:00 Intro and Design Intent
1:20 Sketch
2:47 Sweep Helix edge
3:21 Loft Helix top
3:53 Patch Rectangle
4:02 Revolve Cylinder with mistake
4:20 Boundery Fill and fixing mistake
...
https://www.youtube.com/watch?v=MachxXVr0dY
This is a short video of me designing the Cuboctahedron and Truncated Cube and Truncated Octahedron (archimedean solid) in Fusion 360.
Using no math or angles, making the software do all the "hard" work.
The model is parametric in that there is only one dimension, then changing the dimension in the first sketch the final solid body updates.
Hope this is useful for you out there :)
https://en.wikipedia.org/wiki/Cuboctahedron
https://en.wikipedia.org/wiki/Truncated_cube
https://en.wikipedia.org/wiki/Truncated_octahedron
https://en.wikipedia.org/wiki/Archimedean_solid
...
https://www.youtube.com/watch?v=VljXL1KdmOU
Sometime things look simple but takes some steps to get the geometry correct.
This is from a Facebook question.
I hope this can be useful.
0:00 Intro and Design intent
1:10 Create the cone body
2:05 Sketch the Rectangle
2:53 Project Rectangle to Surface
4:00 Sketch Path of Extrude (side view)
5:40 Plane along Path
5:50 Sketch Project Extrude profile
6:28 Extrude Cut
7:05 Circular Pattern
7:20 Editing dimensions
...
https://www.youtube.com/watch?v=Z_imovRajhc
This is how auto project geometry behaviors in Fusion.
I have this turned off.
0:00 Intro
0:26 Sketch with ghost profile (auto projection)
1:12 Turn off Auto project geometry
1:32 Sketch with no auto projection
1:51 Manual projection if needed
...
https://www.youtube.com/watch?v=bQzryQLa3CA