Bob Stone hydroboost with 40mm master cylinder, 80mm front calipers, 80mm mid axle calipers, and 66mm rear calipers. Brake pressure at caliper 1,600 psi. Steering pump at 1,650 psi. Rear brake pressure video here https://youtu.be/1BZdAva7wqc
...
https://www.youtube.com/watch?v=x7_mwmyEDaY
Testing how a Crane HI-6N works driving a GM DIS coil. Not a matched component deal but it should work. The plan is to have the 6N box triggered by a Ford crank position sensor and driving a GM DIS coil in a wasted spark configuration. All of this to get away from point style ignition on an Onan generator and have the ability to run large plug gaps. I'm testing here to see if the coil and box can live with each other. Camera was at 30 frames/second and trigger was at 30 cycles/sec. They must have actually been a little different as the video shows initial spark and tigger coming and going. It looked continuous in real life.
...
https://www.youtube.com/watch?v=g1twtVkMlPs
Plasma was getting to where it would light off even with new consumables. Opened up the spark gap a little to about .042". Lights off consistently now.
...
https://www.youtube.com/watch?v=FN3dGqr4mAw
Depth of cut .020 feed .010. Steel 3/4 X 4 fabbing a low budget press brake. This will be the top die with an angle of 80 degrees.
...
https://www.youtube.com/watch?v=o6cgGuv2RUU