How To Mechanic 101: 2009 (Z12) Nissan Cube Engine Removal Prep (First Time)
If ya need to know how to get your engine removed from a Z12 Cube, here’s a little something to help get ya along the way.
Or maybe you’re just curious what’s it like to mechanic without manuals and directions how to do a new job, here’s how I go about doing things. I don’t suggest you copy me, this is just how I did this particular job and hoped maybe it may help someone else.
First I wanna thank you all so much from the bottom of my heart for being here.
Very different type of upload for me, though I felt it was time to be 100% honest with y’all about how things work here for me. It’s not just about YouTube and cars, I’m here to engage with each and every one of you. Many of you are like a glimpse into the outside world. Thanks for bearing with me, this was rough. Not a big fan of holidays, mainly cause so many have forgotten what they’re really about. Especially Christmas.
...
https://www.youtube.com/watch?v=x3V09WzXkJI
Instructional how to make you own car or truck ramps for a lowered for under $30 at your local hardware and lumber supply.
Supplies needed for the job:
~ Two 2x8x10 or 2x10x10
~ Circular saw with angle adjustment
~Drill w/ desired bit attached
~ 3” construction screws with the desired screw head and bit or your choice. I used a T25 Torx bit screw set for $7 at Home Depot
~Tape measure
~marking tool (I used a ball point pen)
Takes about 20-30 minutes for experienced builders.
Board lengths are:
44”
33”
22”
16”
5”
Angles used are:
15deg
45deg
#DIY #Homemade #Ad
...
https://www.youtube.com/watch?v=-31NgWf4qX8
Make sure you set your subscriber setting to public, if you wanna be entered into the giveaway. I can’t see you’re a sub if it’s set to private.
As far as the vise goes, uhh... maybe a 4th will show up? Idk if I get a refund too, I might do a torture test on one of them.
#Giveaway #eBay #Sunjoe
...
https://www.youtube.com/watch?v=v1nKHaxM4cQ
Never been a huge fan of VW, but this one surprised me. Have a watch and let me know what you think of this TDI Jetta and it’s “Evry mod” on this little ride along.
#VW #TDI #EvryMod
...
https://www.youtube.com/watch?v=-ehg4SVLDGU
Make sure to check them out:
Custom engine stand made by Vein Engine Stands
www.Veinstands.com
@veinenginestands on insta
Email: veinstands@gmail.com
Custom powder coating by Velocity Powder Coating
www.velocitypcco.com
@velocitypowdercoating on instagram
Follow us on Instagram @monkey.wrenching
...
https://www.youtube.com/watch?v=JluYi-XXwu0