I'm back! It has been a busy few weeks and people have asked me about the progress on the FolgerTech FT-6 and CR-10S upgrade!
On the FolgerTech FT-6, the build seems to be largely done but it hasn't been the easiest thing to complete! Watch!
Yes, remember that FT-5 I had that was plagued with a warpy bed? While I am saving up for the remaining components to upgrade it, I gave Marlin 1.1.9 a try, bringing the firmware up to date. With babystepping able to compensate on that first layer, it seems there is hope!
And the CR-10S upgrade, where I replaced the entire hot end with a genuine E3D Titan Aero, lightweight E3D motor and EZABL probe. What made this possible? The impressive....yet complicated...Petsfang Aero Evolve!
Link:
https://www.thingiverse.com/thing:3279302
Mentioned in the video:
Extrusion Multiplier calibration cube test
https://www.thingiverse.com/thing:2490893
E3D Extruder Steps per mm (see step 5)
https://e3d-online.dozuki.com/Guide/Titan+Aero+Marlin+Configuration/39Thanks for watching and pleasure Subscribe!
⭐ Support me and my Channel with a Donation! ⭐
https://www.paypal.me/wherenerdyiscoolWant to save some money on your next FolgerTech purchase? Use WHERENERDYISCOOL coupon code at checkout!
Also use Coupon Code "NerdyisCool" for 15% off at ZYLTech!
...
https://www.youtube.com/watch?v=XMhtd2zSV40