I made a fly cutter out of some scrap mild steel.
A good machining job. I will make a set of these in different sizes.
Very Handy!!
...
https://www.youtube.com/watch?v=3-DAExsEHKY
There was a lot of movement in this machine from the nylon insulator.
I machined up a steel rod to replace the nylon and that made a big improvement.
Part two will be fitting a switch.
...
https://www.youtube.com/watch?v=uUYtCwcoHEM
The throttle pedal had a hesitation between 20% and 30% percent.
using the scan tool to fix the problem.
I did a video on the scan tool i used in the link below
https://www.youtube.com/watch?v=wSyfWy4JT7s&t=76s
...
https://www.youtube.com/watch?v=mAFFIVRou20