Got some goodies off of Ebay, thought I would show them off, and a little talk about an unusual boring head setup.
...
https://www.youtube.com/watch?v=j9cFVhzda5s
#KilroysShop #oxtoolco #Kilroy
Back on Tom Lipton's Rod Bender, lots of smokey shaper action, drilling, tapping and general sweating in the shop.
...
https://www.youtube.com/watch?v=meoP2tmtGqw
A response video to Adam Booth (abom79) and Tom Liptons (oxtoolco) ongoing "measurement" contest! Adam, stop telling everyone where the deals are dude, you are ruining ebay!
...
https://www.youtube.com/watch?v=c6UMa86jti0
Demonstration of the annular cutter arbor that was done in a previous video on this channel. The demo is drilling a 1 7/16 hole though an inch of steel plate. The utility of these cutters for home shop use should be obvious.
...
https://www.youtube.com/watch?v=Az-NJRZqyZw
Getting back on the knee crank for the Kearney Trecker 415 S-15. Some drilling, boring, and a little shaper magic. Still fighting the camera shake.
...
https://www.youtube.com/watch?v=PyyyO3lEuAM
The tach on my small lathe hasn't been working and I was finally fed up enough to do something about it. The Rivett 1020 uses a tachometer generator setup and that needed some TLC.
Link to the current Servo-Tek web site
http://www.marshbellofram.com/servo-tek/
...
https://www.youtube.com/watch?v=WbXyuarjv8c
#KilroysShop #FeedTheMonster
Long past time to feed the Monster! We are going to unbox, inspect, and setup a new Everlast Powertig 325 EXT.
...
https://www.youtube.com/watch?v=HrDDuo25Pa0
Got this ratty old Float Lock vise from back when AMF owned the company. Going to give it a little love and see what we can make of it.
Link to Penn Tool Co. who currently carries the Whalstrom Float Lock, the current company selling the design.
http://www.penntoolco.com/wahlstrom-float-lock-drill-press-vise/
...
https://www.youtube.com/watch?v=5BZjm-qtFl8
Having mentioned Creo Direct Modeling Express before I thought I would to a brief demo designing a real part. Not trying to teach you how to use the software, just show how easy it is.
Here is the link to download the package and try it out.
http://www.ptc.com/products/creo-elements-direct/modeling-express/
All I have to say is, this software rocks! And I can afford it!
...
https://www.youtube.com/watch?v=SgH38e-EPs8