u-Link NT can program MPC850 target. This video shows convert DVG1120M(MGCP) to FVG-1120S(SIP).
It also shows how to debrick the device (use slower clock speed).
...
https://www.youtube.com/watch?v=boF9KB9qugM
u-link NT is replacing USB BDM NT to program MC6833X CPU.
u-link NT has the highest clock set to 9MHz instead of 6MHz. The read speed is faster then USB BDM NT.
Connection
Pin 2GND (White)
Pin 3 Freeze (Gray)
Pin 4 Beer (Purple)
Pin 5 Reset (Blue)
Pin 6 DSCK (Green)
Pin 8 DSO (Orange)
Pin 10 DSI (Brown)
...
https://www.youtube.com/watch?v=vNw7D10Znmo
People keep on asking to get BDM NT to program the Volvo CEM since other videos has been told to do so.
u-Link NT has replaced USB BDM NT and can do the programming and better.
In this video, detailed diagram between u-Link NT and Volvo CEM is given.
150ohm resistor is used to enable the erase and programming.
...
https://www.youtube.com/watch?v=4eLyUOnv6lg
This ECM uses MC68377 CPU. The flash is 1M AM29BL802C.
There is no need to pull WP pin as with ECM411.
The definition is the similar as 411. The E40 target will be in the future release of software. If you need it in 1.18or previous release, email me and I will send you the definition file.
...
https://www.youtube.com/watch?v=F4dVJ0HKI94
USB JTAG NT program remote controller (EEPROM) with RMIR.
The free software used to use printer port to program EEPROM but Windows 10 no longer support the printer. With small script we can convert the binary data to and from the RMIR program.
...
https://www.youtube.com/watch?v=EkIapQ4nr9A
Added function of unlock instead of script in earlier version. (1.15).
1 wire BDM for 16 bit MC chip.
The same protocol to program MC9S chip in many ECUs. You simply connect GND, Reset, and BKGD pin to program the flash.
...
https://www.youtube.com/watch?v=9Qjb_nPXAvg