I've been sitting on this flight controller for a good few months - because essentially I needed a good reason to swap it out. With my original flight controller dead, I found a reason. Here are my adventures in getting it set up in my quad. I mentioned the video from R U Sirius about using copper tape to shield your GPS wires - which certainly worked for me. His video can be seen here: https://www.youtube.com/watch?v=63FdNj9pAgM&ab_channel=R.U.Sirius If you liked this video and want to show your support please feel free to join my Patreon supporters here https://www.patreon.com/CurryKitten or if you decide to shop at Banggood, here's a general affiliate link which helps me out if you use it https://www.banggood.com/?p=E81211714085201408XQ If you want to look at other ways of supporting my channel, then check out all the ways you could help out here http://www.currykitten.co.uk/support-me/ ... https://www.youtube.com/watch?v=D0HrTMWdoew

Here's a follow up video to my original Aurora 100 review (which is here https://youtu.be/hY_A_gaxQ70) In this one we examine how much you can torture the supplied lipo (not really recommended), how you can set the PIDs (and other stuff using the OSD), how the failsafe works.... and finally we get out for a bit of a fly. Those lovely people at Banggood sent me this awesome quad. Here's their (affiliate) link for it : http://bit.ly/2qgbQaW In addition to this, the lipos are (at time of writing) back in stock and are here: https://www.banggood.com/Eachine-Aurora-90-100-Mini-FPV-Racer-Spare-Part-2S-7_4V-450mAh-80C-Lipo-Battery-p-1133968.html?p=E81211714085201408XQ Here's the link for the 2nd lipo raw flight: https://www.youtube.com/watch?v=_GGbHpfjdpI I'm looking forward to getting a nice stack of them, because quite honestly you are really starting to get into it after 3 minutes, but then your lipos are all gone and you are forced to stop :( I'll be checking out some alternative lipos as well. ... https://www.youtube.com/watch?v=ANhmv3U3n-c

This is part 1 of this review. Whilst I'm not a fan of a "bench review" it's going to take me a little time (especially with the weather) to build and fly the quad I have lined up, but I think it should be fun to try it out once we get there. This stack was kindly supplied by SpeedyBee for review, so if you'd like to check the product out in more detail, please consider using the following affiliate link: https://www.speedybee.com/speedybee-f405-v4-bls-55a-30x30-fc-esc-stack/?ref=CurryKitten If you liked this video and want to show your support please feel free to join my Patreon supporters here https://www.patreon.com/CurryKitten or if you decide to shop at Banggood, here's a general affiliate link which helps me out if you use it https://www.banggood.com/?p=E81211714085201408XQ If you want to look at other ways of supporting my channel, then check out all the ways you could help out here http://www.currykitten.co.uk/support-me/ ... https://www.youtube.com/watch?v=D7D7gzlLq6g

Let's return to Open.HD at last! In this part, I'm going to revisit the ground vehicle setup in order to try and get some goggles working, whilst also attempting to improve the DVR recording so I can show you guys what's going on. This should be the last ground vehicle Open.HD video before I move over to an Open.HD config on a quad. Here's a link to the blog post talking more about the setup https://www.currykitten.co.uk/open-hd-a-new-setup-and-config-guide/ You can find out lots more useful things for Open.HD in their project page https://github.com/OpenHD/Open.HD This project isn't part of a review series or sponsored by anyone (although I did get the Zeus F7 flight controller and GPS/Compass for free from HGLRC so below are a few (affiliate) links to check out their stuff) Zeus DJI F722 Flight Controller - https://www.hglrc.com/collections/fc/products/hglrc-forward-f722-3-6s-f7-flight-control?ref=nlrq3y-lbgm M81 GPS/Compass module - https://www.hglrc.com/collections/gps-module/products/hglrc-m81-5883-gps-qmc5883-compass-for-fpv-racing-drone/?ref=nlrq3y-lbgm Massive thanks to my Patreon supporters who gave m the resources to buy all the equipment to put videos like this together - thanks guys. If you liked this video and want to show your support please feel free to join my Patreon supporters here https://www.patreon.com/CurryKitten or if you decide to shop at Banggood, here's a general affiliate link which helps me out if you use it https://www.banggood.com/?p=E81211714085201408XQ If you want to look at other ways of supporting my channel, then check out all the ways you could help out here http://www.currykitten.co.uk/support-me/ ... https://www.youtube.com/watch?v=TxCVt61SjLw