This is a short time lapse of my 3040 cutting a replacement gear for a Selphy 740 printer that was broken. The material I cut it from was a stylus I got with a TFT display. It's a bit on the soft side but worked first time when I put it in the printer. the setup isn't ideal You can see the material flex as it is cut.
V1.1 PCBs are here and I have populated a set. The V1.0 PCBs had about 45 problems, have i fixed them all?
Will the PCBs fit in the case better than the first set?
...
https://www.youtube.com/watch?v=b8dYikCsfaM
This is a Rockwell 920/3 calculator, one of the Rockwell 900 series.
Manuals on Katie Wasserman's site:
http://www.wass.net/manuals/
I'm trying to pull all the information I have on this calculator here:
https://sites.google.com/d/1V14QzSjnWO_XDMreRE1ATJx_TDg5Z-i-/p/1Mi0Xp-P4tiJmt7-axZWRxEv-ChLhPQqZ/edit
...
https://www.youtube.com/watch?v=mRxRr7Xm_wA
This is an example test cut using the cantran. It's a repeating pattern over the whole can. This is sped up by a factor of 20.
...
https://www.youtube.com/watch?v=46fwLUoGa0g
The case is opened by removing six screws on the sides of the case. the knob does not need to be removed. There are two grub screws holding the knob on.
...
https://www.youtube.com/watch?v=Ef3cltqmbWY