Ebay Project Hyper 7 PBS Part 1 Engine removal and electronics test
In this video, i remove the old air filter, take the engine out to check it turns over ok, which it does and check the electronics that came with the Hyper 7 PBS work. Unfortunately, a crystal was missing from the radio, so i used a spare 2.4ghz from my Hyper MT instead. ... https://www.youtube.com/watch?v=uk7X50m8F7o
Spec:
Hobbywing Max6 160A ESC
Surpass Hobby 1700KV 4076 Motor
Yeah racing heatsink
Power HD 20KG servo
Proline badlands
Hyper SST motor mount
48T spur
16T pinion
Spider centre diff
500K centre diff oil
Losi 8ight T battery tray and esc mount
4S Turnigy Heavy Duty 5.0AH
6S Turnigy 5.0AH
Flysky GT5
...
https://www.youtube.com/watch?v=NgYLKxWnP3w
For some reason i was having range issues. It didn't seem to be loosing signal as i had the failsafe set to brake, if i lost signal. when i turned the transmitter off the car stopped.
Other than that it seemed to be tuned up pretty well. I only leaned out the LSN 1/8th. It will not idle forever though, so the tune is still not perfect. I also couldn't hold it open for a full pass in 2nd gear due to the range issues. so it could be a tad lean at the very top end. I also think the exhaust gasket might have been leaking a bit, so i will fix that before the next run :D
Spec:
Team Associated Mini MGT 3.0
Standard 3.0cc engine
AE S1903 throttle and gear change servos
Etronix ET2049 steering servo
Team Magic E5 wheels and tyres
Flysky GT5
...
https://www.youtube.com/watch?v=PEsf5aG28cM
The last run of 2019 with my Xray XB808 Brushless conversion running 4S
Spec:
2011 Spec Xray XB808
Surpass 4076 2000KV
HobbykIng X-Car 120A esc
Savox SW0231MG
...
https://www.youtube.com/watch?v=MIDYKWAHeVo
@Nitro RC Nerds
Whats up, would you mind helping a noob out with your vast nitro wisdom.
The new carb i have ordered is the NOVAROSSI 24069.
I've got a full set of new driveshafts to go in.
...
https://www.youtube.com/watch?v=IS671HubaMQ
Motor tested: Hobbywing SL G2 3652 3300KV
Stats as tested
Real KV: 3301
max DB: 83
Current draw: 1.6A
This motor is used in my Axial SMT10 with a Max10 60A esc on 2-3S
...
https://www.youtube.com/watch?v=GdApzXH3N9U