Original rivet process didn't work too well. Tapped for a screw to hold the friction plates down harder on the ball. It worked! A nice reflection on me... if it hold up. ... https://www.youtube.com/watch?v=RyerRBS_3CY

How Jack's MGA master cyl was rebuilt too many times. Choke cable cleaned and made to work as it should. Peters homemade motor hoist and we'll see Peter get the motor running on the stand tomorrow all by himself! Well mostly by himself but he will be doing most of the work. This is days of work and so it's long. Thanks for watching! Bobby ... https://www.youtube.com/watch?v=OeRdvAl-Iqk

I used a nationwide name brand gasket set and didn't get 25 miles without major problems. Going to pull the motor and just do the whole rebuild, bearings and all. A note in the Ames cat states that some aftermarket head gaskets can leak. There is also a little walk around the barn and will the lift fit on the side of the barn? Thanks for watching. ... https://www.youtube.com/watch?v=cP9y6WksjSE

Getting a TR4 ready for a spray job with some tips and tricks. Thanks for watching! Bobby ... https://www.youtube.com/watch?v=k3aVUut6Gm0