Demonstrates the master caution panel being driven by my 16 channel high-power output board. The output board is required in order to supply the current demands of incandescent bulbs.
...
https://www.youtube.com/watch?v=mKrUuGj8YyA
This video covers all the components that go into a basic PrintNC CNC control box. The enclosure design is patterned after the unit shown in the PrintNC wiki. Changes to layout and features have been made in order to suit my particular build.
The wiring done in the box is a vague mix of "best practice" and "adequate practice". It meets my needs, but may not meet yours. Copy my technique at your own peril. ?
...
https://www.youtube.com/watch?v=hIL2zlkcVbA
This (admitted rather long) video shows how to install the "1013" auto-level probe upgrade on the LulzBot TAZ 3D printer.
The parts files and instructions can be found here:
http://forum.lulzbot.com/viewtopic.php?f=16&t=166
...
https://www.youtube.com/watch?v=dNqr_FqxrYs
Ahh yes, another project! This time the ShopBot is finally getting a well earned upgrade! In this video I go over what it's gonna take and what will happen during the process.
...
https://www.youtube.com/watch?v=NeqMVtSpOmw
The PrintNC CNC machine is finally complete!
The process took over 2 years over $4400 to complete.
Was it worth it? Probably not, but I'll find out sooner or later. ?
Check out the G.O.A.T. Spoilboard by Eigen Designs here: https://www.youtube.com/watch?v=wm2yL85eNJE
The coolant line & VFD cable clips I made can be found here:
https://www.printables.com/model/907896-coolant-vfd-cable-clips
The quick-disconnect spindle fittings can be purchased from PwnCNC (not affiliated) here: https://pwncnc.com/collections/all/products/kool-connectors
The water hose included with the spindle kit is not worth your time. However the Superthane Ether tubing that PwnCNC sells certainly is! (again, no affiliation). You can find the hose I used here: https://pwncnc.com/products/clear-tube?variant=42422360670347&_pos=1&_psq=superthane&_ss=e&_v=1.0
...
https://www.youtube.com/watch?v=YjPjH385b90
This video shows a PC controlling an R/C airplane via a special hardware and software interface. The transmitter used was a Hitec Prism 7 and the joystick connected to the PC is a Logitech Extreme 3D Pro.
...
https://www.youtube.com/watch?v=fiL41-51Duo