Ahhhhhhhhhhhmmmmmmm Ahhhhhhhhhhhmmmmmmm Ahhhhhhhhhhhmmmmmmm Zen ... https://www.youtube.com/watch?v=Bu56G5Zhp-c

Good sandpaper is expensive and crappy sandpaper costs less initially, but you use three times as much and it takes twice as long to sand. If you like my videos, this is one way you can help the channel. I'm an Amazon Affiliate and I get a small fee if you shop through my link. https://amzn.to/2GH6XU3 Thanks! ... https://www.youtube.com/watch?v=WiubYX_1CUg

For the longest time, fitting the 1/4 inch pins, through the 1/4 inch holes drilled through the steel and both sides of the handle was way more difficult than it should be. To remedy it, I started taking a 1/4 inch bit and wiggling it around a bit with the drill turning in the hole. That worked somewhat but left oblong holes that epoxy would seep into and looked awful. The reamer solved all those problems.Another thing I learned was that the wood needed to be 100% square when drilling through it for the pins. Now, before I even mix the epoxy, I do a couple of assembly dry runs just to be sure it will all go well when I spread the epoxy on the knife and handles. If you would like to discuss buying a knife, I can be found here. bctruck@gmail.com If you like my videos, this is one way you can help the channel. I'm an Amazon Affiliate and I get a small fee if you shop through my link. https://amzn.to/36WZOs1 Thanks!! ... https://www.youtube.com/watch?v=wVedJzb49pE

I’m puzzled as to why this has happened twice. I just am at a total loss as to what this does for them. ... https://www.youtube.com/watch?v=3QPfn-1cryE