refreshed the nikki carb. fixed idle issue. modified accel pump.
clutch slave and rear wheel cylinders failed in storage so I have to deal with that. nbd.
she'll be rippin flames soon
...
https://www.youtube.com/watch?v=uSVELBwe7GQ
Josh B from Techno Toy Tuning will be noting the measurements and you should have a perfect fit installation in your case.
Hardware changes needed :
2x 30mm studs for the master cylinder & nuts washers lock washers
Remove 15mm from push-rods beveled end
If you need to DIY just grind down the diameter of the push-rod 3mm or so in small increments until it fits into the pin of the master cylinder, you want the rod to bottom out inside the master. Don't force the pin and operate the master without fluid or you could damage the seals.
...
https://www.youtube.com/watch?v=1UvO-elblZE