Continuing the Beast rotor build. All parts are 3d printed except the magnets, ceramic bearings and acrylic stand.
...
https://www.youtube.com/watch?v=nxlR94IM_uo
So thanks to Sky Collection who spotted the issue I should have being the main shaft was too short and the rotor magnets were interacting with the large ring magnets. I now have to either go back to a pointed shaft end or take out the metal baking plate and swap it for glass. We'll see :)
...
https://www.youtube.com/watch?v=xcf-SnPaTmQ
So I'm starting on the 3rd iteration of Spaceman Aust 3D printed solenoid motor. The first 2 were good but this third version is the best so far. The prints will take a bit longer but hey.........Its worth the wait :)
I also threw in a goofy 3d printed motor but the magnets we're too weak.
...
https://www.youtube.com/watch?v=nbaP2esoCZQ
I just wanted to show the new 3d printed monster rotor update from the resin one. Will show it working soon.
...
https://www.youtube.com/watch?v=M50N1LOAqLQ
So I tested the Big Puck rotor with NSNSNS facing outward and inward and then in the super pole position and even though it seem that the super pole position didn't get a higher rpm I'm still going to use it from now on because I believe it will give a larger pickup coil voltage due to the larger poles.
...
https://www.youtube.com/watch?v=Yk7fd0Odacs