Everything you need to know about different wires, cables and PCB traces!
Courses: https://thedeveloperguy.com/
Support on Patreon: https://patreon.com/thedeveloperguy
...
https://www.youtube.com/watch?v=EGzqK8JSNtY
Use the code "PCBWay-TDG" for $10 off at PCBWay! https://www.pcbway.com/
YOu can get a cheap hotplate, but it's not safe by default. Let's improve it!
...
https://www.youtube.com/watch?v=PlDgq2s5Odg
Patreon: https://patreon.com/thedeveloperguy
Ko-fi: https://ko-fi.com/thedeveloperguy
Native development is getting easier, right? We already created a project in this series, and it's time to configure our microcontroller, without writing a single line of code! Code generation is useful, if you know what you should do.
In this episode we set a GPIO pin as an output and write the embedded Hello World: blink a LED. But we won't use setup(), loop(), pinMode(), digitalWrite() or delay() - STM32s have their own functions for that!
00:00 Introduction
00:35 Pin configuration
01:27 Eclipse perspectives
01:51 main.c
02:10 setup() and loop()
02:33 Code generation
03:29 Generated and user code together?
04:05 Blinky
04:17 pinMode() and digitalWrite()
05:11 HIGH and LOW
05:24 delay()
06:16 Thanks for watching
...
https://www.youtube.com/watch?v=Xz6I7bQoTao
Why buy a playseat if you can make one? This seat is made for the Logitech G29/G920 with shifter. Adjustable pedal, seat and wheel for maximum flexibility!
Chekc out the tutorial on Instructables: https://www.instructables.com/id/Racing-Sim-Seat/
Follow me on instructables and facebook:
https://www.instructables.com/member/thedeveloperguy/
https://www.facebook.com/thedeveloperguy
And if you really liked it, there's a tip jar: https://www.patreon.com/thedeveloperguy
Rollin at 5 Kevin MacLeod (incompetech.com)
Licensed under Creative Commons: By Attribution 3.0 License
http://creativecommons.org/licenses/by/3.0/
...
https://www.youtube.com/watch?v=GLdS3F46ndQ
Being a software developer is hard, especially when it comes to deadlines. but don't fool yourself and everyone else with bad estimations!
...
https://www.youtube.com/watch?v=xWFhfiAPWs4