Here it is after way too long. Releasing it myself because what the fuck ever. Enjoy

A placard I put together with the help of Zona. Mine is going in a little vegetable garden I planted in her memory but you can put yours anywhere :)

The only printable dedicated Mat-9 lower so far that I'm aware of. It is essentially a chopped and frankensteined AWCY Evo AR9 lower with the rear curve of YZY's Montgo lower. Also included is a modified version of Yzy's Montgo-9 which is cut down at the front end to offer a better magwell grip along with a handguard that slides onto the bottom pic rail and meshes seamlessly with the lower (it may take some coercion to put on). Enjoy

This is a printable mold to create a silicone Corona, the flash can version of the Crescent, for reasons Feedback from an HONEST TO GOD TESTER OF THE CESCUSSY. GOD HAVE MERCY: I had to add indexing pins, otherwise the pieces will slide on each other and not stay put. But the indexing pins prevent the top/insert piece from unscrewing liken a corkscrew. I had to pry from the bottom and wedge it out of the mold And then even with the silicone on the insert print, it wouldn't unscrew, i had to peel my edges up and work it off But I'm also using 00-30 shore hardness of silicone, so it could've just been my choice too, and maybe a harder silicone would unscrew better